Introduction

The flat cell panel filter is widely used in steel, electronics, chemical industry, automobile, environmental protection and electric power industries. It is the best intake filter equipment in centrifugal compressor filter room. And various air conditioning system dust removal oil coarse filtration. The product filter material is composed of synthetic glass fiber. Its dust capacity is large, the use cycle is long, mostly used for air primary filter, can be used as the main filter of general central air conditioning, can also be used as the pre-filter of the back end filter, extend the service life of the back end filter.

Flat cell panel filter cleaning

1）. Open the suction grille in the equipment, hold down the buttons on both sides and gently pull down;

2）.Drag the hook on the air filter to pull out the device diagonally below;

3）.Remove dust with a vacuum cleaner or rinse with warm water;

4）. If there is too much dust, use a soft brush and neutral detergent to clean it. After cleaning, shake the water dry and place it in a cool place to dry.

5）.do not use more than 50℃ of hot water for cleaning, so as not to appear the phenomenon of fading or deformation of the equipment, do not dry on the fire;

6）. After cleaning, the equipment must be installed in time. During installation, hang the equipment on the protruding part of the upper part of the suction grille, and fix it on the suction grille.

7）.The last step is to close the suction grille, which is exactly the opposite of the first step. Press and hold the filter signal reset key on the control panel, then the reminder sign of cleaning will disappear;

8）. In addition, I would like to remind you that if there is too much dust in the environment where the air filter is used, the number of cleaning should be increased according to the situation, which is usually half a year.